Subscriber Parameters - Cabletron Systems SmartSwitch 6000 User Manual

# of Trailing Pad Chars
No Response Timer
No Response Retry Count
Delay Timer
Delay Retry Count
NAK Retry Count
VC to be Cleared After Disc
Idle Timer

Subscriber Parameters

Sq (Sequence)
Local Sub
Remote Sub
Autocall
9-14
specifies the number of padding characters that will be added to the end of each frame,
to ensure that the last significant character is sent before the data transmitter switches
off.
is activated after transmission of a general poll or a data frame. On expiry, a NAK–
EOT–General Poll sequence is transmitted, and the No Response Retry Count is incre-
mented. The timer will be de-activated on reception of any valid frame from the line
during Link Down.
specifies how many times the user device will be polled (if it is not responding) before
control is passed on the next cluster (accompanied by other condition checks).
is activated when the application queue is empty; i.e., when data from the network is
pending. On expiry, a TTD (Temporary Text Delay) is sent and the timer is restarted.
After the final retry, an EOT is sent to the line, and a Clear Request is sent to the
network.
specifies the number of times the node will retransmit a TTD when there is no data
pending from the network. Once the count reaches the specified value, the node will
issue an EOT and clear the virtual circuit.
specifies the number of times the node will send a frame when the receiving device is
unable to acknowledge; that is, returns a NAK to the node.
specifies whether the virtual circuit will be cleared after completion of a file transfer.
is activated on reception of an EOT from the line. On expiry, an EOT is sent to the line
and a Clear Request is sent if
is simply a line number to ease selection of a line on the screen to change. To move to
another line, press and enter the sequence number.
[A]
is the ID (subscriber address) of the local end of a BSC connection. (A Subscriber
record must also be configured for this subscriber ID.)
is the ID (subscriber address) of the remote end of a BSC connection. (A Subscriber
record must also be configured for this subscriber ID.)
causes a BSC device to automatically the remote end when it becomes active.
VC to Be Cleared After Disc
is .
Y
FRX/FRM 3.3 User Guide, Rev 04