Node Defaults Parameters - Cabletron Systems SmartSwitch 6000 User Manual

Node Defaults Parameters

Configuring Node Parameters
All possible parameters on the first two Node Defaults screens are listed in Table 3-2,
and the NetView parameters on the third screen are listed in Table 3-3 (on page 3-9).
Descriptions of most parameters follow each table.
Depending on the values configured for some parameters, other parameters might not
be displayed.
Parameter
Node Name
Remote Control ID
Remote Control Pwd
File Transfer ID
File Transfer Pwd
Collecting Node ID
Collecting Node Pwd
Primary Alarm Output ID
Primary Alarm Output Pwd
Secondary Alarm Output ID
Secondary Alarm Output Pwd
Com. Port Thruput
Com. Port Parity
Com. Port Stopbit
Bits Per Character
Collecting Node
Max Congestion
Min Congestion
Periodic Status Timer
Line Idle Timer
Alarm Autocall Timer
Alarm Max Retries
On-Line Temporary Changes
Remember that the software sees uppercase as different from lowercase.
1
Can be:
2
a 1–15 digit number (address).
(FRX6000/FRM only) a COM port:
ports.
(FRX6000/FRM only) a parallel (LPT) port:
0
A value of means that no status will be sent.
3
0
If , the connection will remain active continuously.
4
Continuous retries until connection is established.
5
6 Note that the parameter
changing this parameter on one screen will automatically change it on the others.
Table 3-2 Node Defaults Parameters
Valid Values
up to 8 characters
0–15 digits
0–15 characters
0–15 digits
0–15 characters
0–15 digits
0–15 characters
see footnote
0–15 characters
see footnote
0–15 characters
A–H
0, 1, 3
1, 2
7, 8
Y/N
1–50 (%)
1–50 (%)
0–30 (min)
0–65535
5–3600
0–99
Y/N
C1 or
On-Line Temporary Changes
Default Value
none
none
1
remote
none
1
ftran
none
1
alarms
2
none
1
alarms
2
none
1
alarms
H (9600 bps)
0 (none)
1
8
N
50
25
3
1
4
(sec)
0
(sec)
60
0
(no max)
Y
C2 , plus C3 or C4 if the device contains those
P1, P2, P3.
appears on all three screens;
5
3-5