Configuring Bridge Ports; Bridge Ports Display - Cabletron Systems SmartSwitch 6000 User Manual

Configuring Bridge Ports

13-12
A Bridge port is an FRX/FRM LAN interface or frame relay port that will operate as
a bridge connection to the LAN or WAN.
Press at the LAN Interfaces Configuration Menu to display configured Bridge
[C]
ports.
R eview Bridge Ports/LLC2 I nterfaces
-------------------------------------------------------------------------------------------------------
I nterface Nu mberTyp eR LP
-------------------------------------------------------------------------------------------------------
0 Ethern et
1 Frame R elay 0
2 Frame R elay 0
3 Frame R elay 0
4 Frame R elay 0
PgUp , PgDn, F3:Exit, F9:S top Remote, F10:A bort
Figure 13-4 Bridge Ports Display
These interfaces can be used for either LLC2 or Bridging.
To configure an interface, press
prompted for an
Interface Number
interface):
If modifying an existing record, enter the interface number:
Do not configure more than one interface per DLCI on a port.
If creating a new record, press
available sequential interface number.
The display depends on the interface; the following figure shows an example, and
Table 13-8 lists the parameters for all interface types.
Nod e Name=n ode_xyz
Port DLC IFormat
1 30Native LLC -2
1 318025_SR B
1 328025_SR B
1 338023_TB
[A],[C],[F],[C] from Main Menu
at the LAN Interfaces Configuration Menu. When
[D]
(which is merely a sequential number to identify the
, which will automatically specify the next
[Enter]
.
0–250
FRX/FRM 3.3 User Guide, Rev 04