Frame Relay Dlci Configuration Screen 2 - Cabletron Systems SmartSwitch 6000 User Manual

Viewing Learned DLCIs (Figure 6-4, Item E)
Configuring Frame Relay
Frame Relay DLC I C onfiguration (s creen 2 of 2)
* LP
* Port
* DLCI
A Back up Grou p N umber
B Enable Backu p Protocol
Option:
Figure 6-7 Frame Relay DLCI Configuration Screen 2
If you configure a
replaced by several parameters (listed in Table 6-3 on page 6-15) that
determine backup operation.
If you change
will disappear.
If the port is a logical DTE, a list of all DLCIs (extracted from LMI/AnnexD frames)
can be displayed by pressing
by three columns:— ,
A
: = active, = inactive.
A a I
: = new, = old. (A newly learned DLCI will become "old" after the first
N n o
Full Status Inquiry.
: = configured on the node,
C c
0
7
16
0
N
Backup Group Number
Enable Backup Protocol
at Figure 6-4. Each displayed DLCI will be followed
[E]
, and —with the following possible values:
N C
= not configured.
1
Nod e Name=n ode_xyz
,
Enable Backup Protocol
to , the
Y Backup Group Number
will be
entry
6-13