Configuring Async Port Records; Async Pad Port Screen - Cabletron Systems SmartSwitch 6000 User Manual

Configuring Async Port Records

Configuring Async Ports
Once the necessary Node, Line Processor, and protocol parameters have been con-
figured, press at the Port Configuration Menu (or
[A]
When prompted, enter:
LP number of the RLP containing the port:
FRX4000 or FRM. (The default is
Port number (see port locations in Chapter 5):
The display for an existing port will show the configured parameter values, while the
display for a new port will show default database values. (See Table 10-3 on page 10-
10.) The following figure is an example of an existing port.
As ync PAD Port Parameters
* R LP: 0 Port: 0 Lin k S tate: Link up
* I /O:–RS -232
A Port Type
B Phys ical Port In terface
C Blocked Port Flag
D X .3 Lin e Speed
E I nitial Profile N ame
F Login Required
G Parity
H D CE C able Attached
I Mask Link Alarms
J X .25 Parameter Options
K A utocall Options
L Brows e Profile
M Modem S ign al Options
N D is con nect Op tion s
O On-Line S ystem Memory Chan ges
Option:
Figure 10-2 Async PAD Port Screen
If a record does not exist for the async PAD profile identified by
Profile Name
Database
Pressing , or
[J], [K], [M]
will display the async PAD profile parameters (listed earlier in this chapter) that
[L]
are resident in the FRX/FRM software.
.) (LP numbers are described in Chapter 4.)
0
Databas e System Memory
Asyn c PAD Asyn c PA D
RS-232 RS-232
N N
autobau d autobau d
90 90
N N
0,n one 0,non e
N N
N N
Y
[A],[C],[A]
, the letter will be displayed preceding the name in the
U
column.
will display more parameters, listed in Table 10-3. Pressing
[N]
from the Main Menu.
[A], [C], [A]
0–7 for FRX6000, 0 only for
. (The default is
0–7
Node Name=nod exyz
from Main Menu
.)
0
Initial
10-9