Configuring Ip Interfaces; Ip Interface Record Example - Cabletron Systems SmartSwitch 6000 User Manual

Configuring IP Interfaces

11-4
An IP interface allows the Internet Protocol to be executed over a frame relay, X.25,
or LAN port.
To display all IP interfaces configured on the node, press
Interfaces Menu (or
[A], [C], [F], [A]
To configure an interface, press
prompted, enter an interface number:
identify the interface.)
Do not specify an interface number that has already been used
for an IPX interface, LLC2 interface, or Bridge port on this
node.
The display depends on the interface; the following figure shows an example, and
Table 11-2 (on page 11-5) lists the parameters for all interface types.
I P Interface C onfiguration
* Interface N umber:–10
A Maximum Tran smission Un it
B Network Mask
C Routing Metric Coun t
D ICMP Redirects
E RIP Flash Up dates (s ec)
F RIP Full U pdates (sec)
G Priority
H Bandw id th A llocation Group
I Interface Typ e
J Source IP A ddress
K Destination I P Ad dres s
L Source Card
M Source Port
N Source DLCI
Option:
Figure 11-2 IP Interface Record Example
from the
Main Menu
at the Configure LAN Interfaces Menu. When
[B]
. (This is merely a sequential number to
0–128
Nod e Name=n odexyz
4096
255.0.0.0
0
Y
60
120
5
1
FRL
100.100.2.2
100.100.2.1
0
0
16
[A],[C],[F],[B]
from Main Menu
at the Configure LAN
[A]
).
FRX/FRM 3.3 User Guide, Rev 04