Testing A Translation Template; Address Translation Test Screen - Cabletron Systems SmartSwitch 6000 User Manual

Testing a Translation Template

7-22
Press at the X.25 Address Translation Templates Menu (
[C]
Main Menu) or at the Operations Menu (
[D]
translation template you have created.
When prompted, enter:
LP.
Port.
Direction: (incoming) or
I
Called address to be translated.
Calling address to be translated.
Facility length + facility + user data. (The user data includes four bytes for pro-
tocol ID, which must be entered as a hex string.) To specify only user data, at
the above prompt enter
desired user data, including the 4-byte protocol ID.
After you enter this information, the FRX/FRM creates a test packet and sends it
through the translation process, and displays the results, as shown in the following
example.
Packet Trans lation Tes t
LP:0 Port:0
Original Packet:10010B7712345673333333000100000035353535
C alled Add ress :1234567
U ser Data Protocol ID :01000000Us er D ata: 55555
Facilities:
Trans lation Template:
Template I D:1234C*U *
C alled Add ress :L8401X7
U ser Data Protocol ID : P
Facilities:P
Trans lated Pack et:10010B74840133333330000100000035353535
C alled Add ress :8401
U ser Data Protocol ID : 01000000Us er Data: 55555
Facilities:
S trike any k ey to continu e
Figure 7-9 Address Translation Test Screen
[B], [D]
(outgoing). (Default is
O
for a facility length, nothing for a facility, then the
00
D irection:I ncomin g
Callin g Ad dres s:3333333
Callin g Ad dres s:P
Us er D ata: P
Callin g Ad dres s:3333333
[A], [C], [D], [C]
from the Main Menu) to test a
.)
I
N ode Name=n odexyz
[B],[E] from Main Menu
FRX/FRM 3.3 User Guide, Rev 04
from the