Displaying Port Signals; Port Signals Display - Cabletron Systems SmartSwitch 6000 User Manual

Displaying Port Signals

Information in this Display
17-8
This display lists basic configuration and line status for all serial ports on a specified
LP, as well as signal states (on/off) at the physical interfaces.
Press at the Status Displays Menu and, when prompted, enter an LP number:
[D]
The display will show the first four ports, and pressing
four ports.
Line Process or Status
Port Nu mber:0
Phy Interface:X.21
Port Con fig:FR
Logical Inter:DTE Con fig
Line S peed :1.008M
Line S tatus:Oper
TD(2) ON
RD (3)OFF
RTS (4)OFF
CTS (5)OFF
DS R(6)ON
DC D(8)ON
TC(15) ON
RC (17)ON
DTR (20)ON
F2:Next LP C ard F9:S top RemoteF10:Ab ort Remote
PgUp:Firs t 4 Ports PgDn :Last 4 PortsOth ers:Exit08:14:52
Figure 17-5 Port Signals Display
is self-explanatory.
Port Number
is the type of connector on the port. On an FRX6000, this is the con-
Phy Interface
nector on the I/O cable exiting the port's I/O box connector toward the
subscriber device. (This information is taken from the Port record.)
is the port type (
Port Config
If no record has been created for this port,
this line and the one below it.
is the logical interface,
Logical Inter
no record has been created for this port,
line and the one above it.
Line Speed is the speed configured in the Port record.
: (level 2 is down)
Line Status Failed
Disconnect
Restart
Not_configured
Operational
Nod e Name=nod e_xyz
LP: 0 In terface: RS-422
1 2 3
R S-449 X.21
No SN A FR
D CE DC E
1.472M 2.048M
Op er Oper
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON \
, ,
FRL SNA X25
or
DCE
(level 2 is up; level 3 is down)
(level 3 is restarting)
(port is not configured)
(level 3 is up)
will display the other
[PgDn]
[C],[D] from Main Menu
, etc.) as configured in the Port record.
No Config is displayed on
, as taken from the Port record. If
DTE
is displayed on this
No Config
FRX/FRM 3.3 User Guide, Rev 04
.
0–7