Cabletron Systems SmartSwitch 6000 User Manual page 100

T1 Link Integrity Timer
T2 Polling Verification Timer
On-Line System Memory Changes/Database Display
Enable Outgoing Rate Control
Enable Bandwidth Allocation
For Backup Use Only?
Automatic DCE
DLCI Parameters
Committed Information Rate (In/Out)
Committed Burst Size (In/Out)
6-18
declared active after that poll. (If the
count, the DCE will be declared inactive, and the
determines how often the logical DTE will initiate a Status Enquiry message to the
DCE.
indicates how long the logical DCE will wait between Status Enquiry messages from
the DTE before recording an error.
determines which set of values will change, as described under "Database and System
Memory Values" on page 5-4.
determines whether the rate parameters (CIR, BC, BE) will be enforced.
determines whether bandwidth allocation (described on page 6-6) will be enforced.
determines whether all DLCIs on the port will be reserved exclusively as backups for
other DLCIs in the same node. See "Configuring Frame Relay Backup Groups" on
page 6-35. If this parameter is set to
backup.
If configuring the port for backup use only, make sure no DLCIs on the port
have been configured on an IP, IPX, or LLC2 interface.
enables (if ) automatic detection by the software of whether the port is a physical
Y
DCE or DTE. This can be helpful in cases such as a connected backup CSU/DSU,
which might be configured differently than the primary connection. The automatic
DCE feature allows switchover to occur without reconfiguring the port.
(CIR) is the incoming or outgoing (depending on the parameter) data throughput that
the network agrees to support under normal conditions. If congestion occurs while
throughput is greater than the CIR, and
immediately drop to the CIR value.
(B ) is incoming or outgoing (depending on the parameter) the maximum amount of
C
data that the network agrees to transfer under normal conditions within the time period
defined by B /CIR. Any data exceeding B
C
turned on, and will be tracked by the FRX/FRM statistic
Turning on the DE bit will not automatically cause a packet to be discarded, but will
tell the network which packets it can discard if traffic becomes too heavy.
is exceeded during the
N2 Error Threshold
count will be restarted.)
N3
, the port will remain disabled until needed for
Y
Enable Outgoing Rate Control
will have the Discard Eligibility (DE) bit
C
DE/sec (*10)
FRX/FRM 3.3 User Guide, Rev 04
N3
is , the rate will
Y
.