Configuring Subscriber Addresses; Svc Subscriber Display - Cabletron Systems SmartSwitch 6000 User Manual

Configuring Subscriber Addresses

Configuring Frame Relay
This operation configures the called and calling addresses that will be used in call
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
Routing Paths Menu (or
To add or change a Subscriber ID, press
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described in Appendix A).
SV C Sub scriber Main ten ance
* S ubs criber ID
A S ubs criber Name
B R outing Algorithm
C S ystematic Redirection
D R ed irect on Busy
E R ed irect on Ou t of Order
F C onnection Priority
G R outing Path s
H R ed irection Ad dres ses
Option:
Figure 6-9 SVC Subscriber Display
Pressing will display configured routing paths, which link the subscriber device
[G]
with one or more ports. Pressing
rection. (These addresses are valid only if
D, and E on the first screen.) Parameters for all three screens are described following
Table 6-6 (on page 6-30).
from the Main Menu).
[A], [D], [A]
at the Connections and Routing Paths
[B]
0100012345
sub 1
0, Roun d Robin
N
N
N
0
[A],[D],[B]
will display a list of addresses used for call redi-
[H]
is specified for one or more of items C,
Y
at the Connections and
[A]
Node Name=nod e_xyz
from Main Menu
6-29