Frx4000 Line Processor Parameters - Cabletron Systems SmartSwitch 6000 User Manual

FRX4000 LP Parameters
Protocol
4-4
Table 4-1 FRX4000 Line Processor Parameters
Parameter
Protocol "n"
All of these might not be available on an FRX4000. It depends on which protocols were
1
purchased. Also, note the guidelines in the explanation. (Note that
Service Point.)
determines which protocols can run in the node. Although the FRX4000 contains a
group of protocols in the software when shipped to the customer, they must be loaded
into the operating software (by configuring them in the LP file, then rebooting the
node).
IP-R is a limited IP function necessary for support of the SNMP agent. It
does not support IP routing across the network. LLC2-R is a limited LLC2
function that supports SDLC/LLC2 conversion for transmission of SNA
over frame relay. It does not support full LLC2 sessions.
Follow these guidelines when configuring protocols:
RIP is a valid choice only if IP or IP-R is already specified.
If SNMP is configured, IP or IP-R must also be configured.
If LLC2 is configured, BRIDGE must also be configured.
If NVSP is configured, LLC2 and BRIDGE must also be configured.
In order to configure a protocol on a port, the protocol must be configured
in the LP record.
Valid Values
None, X.25, Frame Relay, Async, SDLC,
BSC-I, BSC-B, IP, IP-R, SNMP, RIP,
LLC2, LLC2-R, IPX, NVSP, BRIDGE
Default Value
next in list not
1
already configured
NVSP
is NetView
FRX/FRM 3.3 User Guide, Rev 04