Configuring A Dial Port; Dial Port Parameters; X.25 Port Dial Parameters - Cabletron Systems SmartSwitch 6000 User Manual

Configuring a Dial Port

Dial Port Parameters

Dial Support
7-12
If the port will be connected to an auto-dial modem, configure the parameters on the
following screen.
X.25 Port Parameters (screen 6 of 6)
A D ial S upp ort
B I nactivity Timer (minutes)
C D is con nect Timer (s ec)
D Line S etu p Timer (sec)
Option:
Figure 7-4 X.25 Dial Port Parameters
Parameter
Dial Support
Inactivity Timer (minutes)
Disconnect Timer (seconds)
Line Setup Timer (seconds)
specifies whether this port is connected to a dial modem and, if so, whether connec-
tions will be initiated through dial-in or dial-out calls. (Signaling differences prevent
configuration for both dial-in and dial-out on the same port.)
A dial-out port will establish a link only when an outgoing X.25 call is placed, at
which time the port will raise DTR and the attached modem will dial a stored number
to a remote modem to establish an X.25 connection. A dial-in port will establish a link
only when a call is received.
If this port is configured as a network trunk, the value for
Databas e System Memory
Dial In Dial In
5 5
5 5
1 1
Table 7-3 X.25 Port Dial Parameters
Valid Values
None, Dialout, Dialin
1–30
1–255
1–255
Node N ame=nod exyz
Default Value
None
5
5
5
must be
Dial Support
FRX/FRM 3.3 User Guide, Rev 04
.
None