Cabletron Systems SmartSwitch 6000 User Manual page 210

Frame relay module for mmac-plus
Hide thumbs Also See for SmartSwitch 6000:
Table of Contents

Advertisement

Timeout if No Call
Timeout if No Data
Disconnect if Clear Recvd
Disconnect if Clear Sent
10-14
If the user logs out, the
be disconnected.
This parameter should be
will periodically be output. (This is harmless, but unnecessary.)
This parameter is automatically disabled on a PVC connection.
if set to
, starts the disconnect timer as soon as the user logs in or a virtual circuit is
Y
cleared, and the PAD is ready to receive commands from the user. The timer is reset
every time the port receives or transmits a call.
This parameter is automatically disabled on a PVC connection.
if set to
, starts the disconnect timer as soon as a virtual circuit is connected. The timer
Y
is reset every time the port receives or transmits a character. If
user has escaped from the data transfer state (by pressing
the port will not be output through the port.
When the disconnect timer expires, the software will check for any data waiting to be
output, as well as the state of the user. If there is data waiting and the user has escaped
from data transfer state, the user will be returned to data transfer state, and the dis-
connect will be canceled.
This parameter is automatically disabled on a PVC connection.
determines whether the user will be logged out if he receives a Clear Request from the
network. Also, if
Disconnect Timer
, the modem signals will be dropped when the user is logged out.
0
This parameter is automatically disabled on a PVC connection.
determines whether the user will be logged out if he sends a Clear to the network.
Also, if
Disconnect Timer
modem signals will be dropped when the user is logged out.
This parameter is automatically disabled on a PVC connection.
will be ignored, and the line will immediately
Disconnect Timer
for a leased line; otherwise, the PAD banner and prompt
N
and
Disconnect Duration
and
Disconnect Duration
is specified and the
Y
), any data sent to
[Ctrl] [P]
are set to values other than
are set to values other than
FRX/FRM 3.3 User Guide, Rev 04
, the
0

Advertisement

Table of Contents
loading

Table of Contents