Subscriber Parameters; Svc Subscriber Parameters - Cabletron Systems SmartSwitch 6000 User Manual

Subscriber Parameters

Subscriber Name
Routing Algorithm
8-14
Parameter
Subscriber Name
Routing Algorithm
System atic Redirection
Redir ect on Busy
Redir ect on Out of Order
Connection Priority
1st,2nd,etc. Path Configured
LP
Port
Redir ection Address 0,1,etc.
1 The software does not verify that the specified LP/port exists. Make sure the specified
LPs and ports are configured in the database, and that they actually exist.
identifies the subscriber to the console operator.
allows creation of a "hunt group" of ports (see example in Appendix B), for the
purpose of routing per a pre-selected algorithm:
= Round Robin – selects ports specified cyclicly in numerical order according
0
to the list of Redirection Addresses. If the selected port is unreachable or con-
gested, the Call Request will be sent to the next port. (If the port becomes
available again, it will be included in its assigned position.)
= Alternate Route on Line Failure – selects the first port that is not in a failed
1
state. If the selected port does not make a connection, the call will be cleared, even
if other ports are available.
= Alternate Route on Line Busy – selects the first port that has LCNs available
2
(is not busy). If the port has failed, the next available port will be selected.
= Least LCN with Throughput – selects the line with the minumum loading, cal-
3
culated by weight and number of LCNs in use on that line. (Each line is assigned
a weight proportional to its throughput within the routing path.)
If use of a routing algorithm is not desired, simply accept the default, and specify only
one routing path.
See "Configuring a Hunt Group for SNA Subscribers."
Table 8-3 SVC Subscriber Parameters
Valid Values
0–31 characters
0–3
Y/N
Y/N
Y/N
0–9
Y/N
FRX4000, FRM:
FRX6000:
Physical port:
Logical port:
valid address
Default Value
none
0
N
N
N
0
N
1
0
1
0–7
0
1
0–7
1
8-63
0
none
FRX/FRM 3.3 User Guide, Rev 04