Configuring Subscriber Addresses; Typical Svc Subscriber Screen - Cabletron Systems SmartSwitch 6000 User Manual

Configuring Subscriber Addresses

9-16
This operation configures the called and calling addresses that will be used in call
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
Routing Paths Menu (or
To add or change a Subscriber ID, press
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described in Appendix A.)
SV C S ubs criber Maintenan ce
* S ubs criber ID
A S ubs criber Name
B R outing A lgorithm
C S ystematic R ed irection
D R ed irect on Busy
E R ed irect on Ou t of Order
F C onnection Priority
G R outing Paths
H R ed irection Add ress es
Option:
Figure 9-5 Typical SVC Subscriber Screen
Pressing will display routing paths, which link the subscriber with one or more
[G]
ports. Pressing will display the addresses used for call redirection. (These
[H]
addresses are valid only if
first screen.) Parameters for all three screens are described following Table 9-3.
from the Main Menu).
[A], [D], [A]
at the Connections and Routing Paths
[B]
0100012345
sub 1
0, Roun d R obin
N
N
N
0
[A],[D],[B]
is specified for one or more of items C, D, and E on the
Y
at the Connections and
[A]
Node N ame=nod exyz
from Main Menu
FRX/FRM 3.3 User Guide, Rev 04