Configuring Ipx Interfaces; Ipx Interface Record Example - Cabletron Systems SmartSwitch 6000 User Manual

Configuring IPX Interfaces

12-10
An IPX interface allows an FRX/FRM to connect to a Novell IPX network. Press
at the LAN Interfaces Configuration Menu (or
display configured IPX interfaces.
To configure an interface, press
prompted, enter an
Interface Number
identify the interface.)
Do not specify an interface number that has already been used
for an IP interface, LLC2 interface, or Bridge port on this node.
The display depends on the interface; the following figure shows an example, and
Table 12-7 through Table 12-10 list the parameters for all interface types.
IPX Interface C onfiguration
* In terface Nu mber
A Block ed Port Flag
B In terface Type
C Frame Type
D Maximu m Trans mis sion U nit
E IPX Network Add ress
F Priority
G Band width Allocation Group
H Port Diagnos tics Enabled
I NetBIOS Enab led
J NetBIOS Hops
K Periodic RI P Enabled
L Periodic RI P Timer (s ec)
M Periodic SA P Enabled
N Periodic SA P Timer (s ec)
O Ad dition al IPX Parameters
Op tion :
Figure 12-4 IPX Interface Record Example
[A], [C], [F], [E]
at the LAN Interfaces Configuration Menu. When
[F]
: . (This is merely a sequential number to
0–63
2
N
Ethern et
TYPE_II
4096
00000001
0
1
Y
N
8
Y
60
Y
60
[A],[C],[F],[F]
from Main Menu
from the Main Menu) to
FRX/FRM 3.3 User Guide, Rev 04
[E]