1. Manuals
  2. Brands
  3. Cabletron Systems Manuals
  4. Network Hardware
  5. SPECTRUM FRX6000
  6. Installation & setup manual

Cabletron Systems FRX6000 Installation & Setup Manual

Cabletron systems user guide smartswitch netlink frx4000, frx6000
Hide thumbs Also See for FRX6000:
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual See also: Reference Manual, Maintenance Manual
Enlarged version
,QVWDOODWLRQ
6HWXS
*XLGH
The Complete Networking Solution
TM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FRX6000 and is the answer not in the manual?

Questions and answers

Related Manuals for Cabletron Systems FRX6000

Summary of Contents for Cabletron Systems FRX6000

  • Page 1 ,QVWDOODWLRQ 6HWXS *XLGH The Complete Networking Solution...

  • Page 2: Statements Of Compliance

    Related Documents A copy of the Netlink FRX4000 and FRX6000 User Guide should always be on site at each FRX6000. Copies of this and other Cabletron documents can be ordered from Cabletron Systems or your local distributor of Cabletron products.

  • Page 3: Site Requirements

    9600 bps, you must connect a keyboard and VGA monitor to the node, in order to rerun part of the FRX6000 software installation procedure to change the configuration. (Each FRX6000 is shipped with cabling to allow connection to an ASCII terminal or PC with terminal emulation) Installation &...
  • Page 4 Do not support a rack-mounted node only in the front. It must be supported at both front and rear. 4. Plug all cables into the appropriate connectors at the rear of the FRX6000, and tighten the retaining screws on each cable connector that has them. (It does not matter which end of an RLP cable plugs into the RLP.) Figure 1...
  • Page 5 2400, or 4800 bps, you must reconfigure the FRX6000 software, which requires a VGA monitor (and keyboard). Connect the monitor to the VGA port on the FRX6000 (see Figure 1) and plug the keyboard cable into the keyboard connector. 2. Plug the FRX6000 and VGA monitor power cables into the appropriate power source, then switch the monitor on.

  • Page 6: Vga Monitor

    VT100 (ASCII) mode VGA Monitor 1. Connect the monitor to the VGA port on the FRX6000 (see Figure 1) and plug the keyboard cable into the keyboard connector. 2. Plug the FRX6000 and VGA monitor power cables into the appropriate power source, then switch the monitor on.

  • Page 7: Check For Proper Operation

    RLP. Some messages are written to a file called BOOTRPT.TXT. Once the FRX6000 software is running, this file can be dis- played. (See "Displaying Boot-up Information" on pge 11.) Once the software has loaded, a screen similar to the following will be dis- played.
  • Page 8 As the node boots, screen information tracks the loading of RLPs, verifies con- figuration file format, and displays any errors. This data is displayed only until the FRX6000 software is running; however, most of it is saved in a file named BOOTRPT.TXT, and the operator can later display it in a report.
  • Page 9 The Complete Networking Solution Document number 09-41-06-144-02...

This manual is also suitable for:

Netlink frx4000

Table of Contents

Save PDF