Single Ethernet To Fddi Lan - Cabletron Systems SPECTRUM FDM Manual

Single Ethernet to FDDI LAN

Single Ethernet to FDDI LAN
To model a single Ethernet LAN to an FDDI LAN in SPECTRUM, follow this
procedure:
1. Create a LAN_802_3 conceptual model.
2. Create an FDDI conceptual model.
3. Create a BdgCSIFDM model.
4. Navigate into the LAN_802_3 and create an MMAC-FNB model
5. Navigate into the Device Topology (DevTop) View of the MMAC-FNB
6. Navigate into the DevTop View of the BdgCSIFDM model, copy the
Do NOT use CUT and paste to move the HubCSIFDDI icon onto the FDDI
model. Use COPY and paste.
!
CAUTION
7. In the BdgCSIFDM DevTop View, move the MMAC-FNB model's Off-Page
8. SPECTRUM creates the Off-Page Reference and pipe connections
This completes the procedure for modeling a single Ethernet to FDDI LAN.
Figure 2-1 illustrates modeling a single Ethernet to FDDI LAN with the FDM.
Modeling the FDM
2-2
representing the hub in which the FDM is installed.
model and copy the BdgCSIFDM icon to the appropriate port on the Port
Connections Panel.
HubCSIFDDI hub icon from the Port Connections Panel, and paste it into
the FDDI model.
Reference to the appropriate port in the Port Connections Panel.
automatically (refer to Figure 2-1).
Management Module Guide
FDM