Configuring A Model Number - Cabletron Systems SmartSwitch 6000 User Manual

Configuring a Model Number

14-8
Identification of the hardware chassis is necessary if an OmniView network manager
device will access the node. OmniView displays a graphic representation of the con-
figured chassis.
If the node will not be accessed by OmniView, configuration of a model
number is not necessary; however, configuring it now will avoid a problem
if OmniView is used at a later time.
To configure a model number, press
from the Main Menu). The currently configured model will be displayed. If the
[D], [D]
value needs to be changed, press
= FRX6000 Model 2
2
= FRX6000 Rackmount
3
= FRX4000
6
7 = Frame Relay Module (FRM)
The Rackmount chassis is currently the only standard model of FRX6000;
however, Model 2 is supported for existing customers.
at the SNMP Configuration Menu (or
[D]
, then enter the correct value:
[A]
[A], [A],
FRX/FRM 3.3 User Guide, Rev 04