Cabletron Systems SmartSwitch 6000 User Manual page 348

18-8
317.
Rcv Err Ratio exceeded T:"n" C:"n"
Severity: 4
Meaning: The port statistic
(
T:"n"
Action: If this happens frequently, check the line for noise, and check for
configuration errors on both the port and the connected device.
318.
Rcv Port Usage exceeded T:"n" C:"n"
Severity: 4
Meaning: The port statistic
threshold (
value.)
Action: If this happens frequently, you may need to add ports or reroute
some traffic.
319. T
rn Port Usage exceeded T:"n" C:"n"
Severity: 4
Meaning: The port statistic
threshold (
value.)
Action: If this happens frequently, you may need to add ports or reroute
some traffic.
377.
LIC "n" Installed, Not Configured
Severity: 3
Meaning: The specified Line Interface Card (LIC) exists in the node, but has
not been configured in the Line Processor file.
Action: Configure the LIC or remove it from the node.
378.
LIC "n" Configured, Not Installed
Severity: 1
Meaning: The specified Line Interface Card (LIC) has been configured in the
Line Processor file, but does not exist in the node.
Action: Install the LIC or delete its record.
379.
LIC "n" Config Mismatch - Type "n"
Severity: 2
Meaning: The interface type of the specified Line Interface Card (LIC)
installed in the node is different from the interface type configured
in the Line Processor file. As a result, the software did not load
properly and will not operate.
Action: Change either the card or the file.
Receive Error Ratio
) that was set by the user. (
% Receive Port Utilization
) that was set by the user. (
T:"n"
% Transmit Port Utilization
) that was set by the user. (
T:"n"
has exceeded the threshold
is the current value.)
C:"n"
has exceeded the
is the current
C:"n"
has exceeded the
is the current
C:"n"
FRX/FRM 3.3 User Guide, Rev 04