Lan Card Configuration Screen; Lan Card Parameters On Frx6000 - Cabletron Systems SmartSwitch 6000 User Manual

LAN Card Parameters
Type
Locally Admin. MAC Addr
Configuring Cards and Protocols
To configure a record for a LAN card in an FRX6000, press
ration Menu. (Unlike serial ports, there are not separate files for the cards and the
ports.) When prompted for an
responds to the card as defined in PROTOCOL.INI.
LA N C ard C onfigu ration
* Interface N umber: 0
A Type
B Locally Ad min MAC Ad dr
Option:
Figure 4-6 LAN Card Configuration Screen
Press after making any changes, to send the configuration to the LAN interface.
[F7]
If the node is connected to a LAN after this record is created, or if the node
becomes disconnected from the LAN, the LAN connection must be ini-
tialized/re-initialized by opening Lan Card Configuration, then pressing
to send the configuration to the LAN interface. (Be sure the FRX6000
[F7]
is connected to the LAN before performing this operation.)
Table 4-5 LAN Card Parameters on FRX6000
Parameter
Type
Locally Admin MAC Addr
Must match the installed card that corresponds to the specified
1
is the type of LAN card.
is a MAC address that will override the universally administered MAC address. If all
zeros are specified, the universal address will be used.
, press
Interface Number
Nod e Name=n odexyz
Token Ring
400000000001
[A],[C],[C]
Valid Values
Ethernet, Token Ring
000000000000–7ffffffffffff
at the Port Configu-
[C]
or , whichever number cor-
0 1
from Main Menu
Default Value
1
Ethernet
000000000000
Interface Number .
4-11