Cabletron Systems SmartSwitch 6000 User Manual page 201

08, Discard Output
09, Padding After <cr>
10, Line Folding
11, Speed
12, Flow Control
13, Insert <lf> after <cr>
14, Padding after <lf>
15, Editing
16, Character Delete
Configuring Async Ports
= no action.
0
= PAD will send an interrupt packet to the remote end but will remain in data
1
transfer mode.
= PAD will reset the virtual call and remain in data transfer mode.
2
= PAD will send an indication of a Break message to the remote end and
4
remain in data transfer mode.
= PAD will escape from data transfer mode and enter command mode.
8
= PAD will discard output.
16
allows a PAD to discard the contents of user sequences in packets on request, rather
than disassembling and transmitting these to the user's device.
determines how many (if any) NULL padding characters will be added after a carriage
return character.
provides for automatic insertion of appropriate format "effectors" in the character
stream transmitted to the user's device. The number indicates maximum characters per
line.
is either the X.3 Line Speed specified in Port configuration or, if autobaud was spec-
ified, the speed of the async device connected to the port. The speed cannot be
changed in the PAD Profile record.
allows XON/XOFF from the user's device to control the rate of data transfer from the
PAD.
causes a linefeed to be inserted after a carriage return in the specified instances. Values
(can be added) are:
= none.
0
= after CR in transmission to the DTE.
1
= after CR in return from the DTE.
2
= after CR in echo to the DTE.
4
determines how many (if any) NULL padding characters will be added after a
linefeed.
provides for character delete, line delete, and line display editing capabilities in the
PAD command state and data transfer state for the user's device. If editing is enabled,
the PAD will suspend forwarding of data packets after expiration of the idle timer or
if the editing buffer is full.
is the ASCII value of the character that is used to delete characters. When this char-
acter is received by the PAD, it will be stored in the editing buffer, and will cause the
10-5