Sna Port Pu Parameters - Cabletron Systems SmartSwitch 6000 User Manual

Port Type
Configuring SNA
Parameter
PU Name
Local Subscriber ID
Remote Subscriber ID
Maxdata (Max I-Frm bytes /frame)
Autocall
Autocall Retry Time
Autocall Retry Count
Istatus
LPDA Resource ID
LLC2 Connection
L2 DatMode
LLC2 Parameters
Local SAP Address
Local MAC Address
IDBLK
IDNUM
3
(100 msec)
T1
3
(msec)
T2
3
(sec)
Ti
3
N3
3
Tw
3
N2
3
Priority
Bandwidth Allocation Group
1 If the PU will be used for SDLC-LLC2 conversion (at the local node, or at a remote node
via a logical or physical X.25 port), this must be
2 In multiples of 4.
3 Will override the value configured for the same parameter in the Node Defaults file, with
two exceptions—if
, the value in Node Defaults will apply.
cation Group
4 Must be less than the value for
delayed acknowledgment before
defines the protocol the port will support. Selecting this parameter will display a list
of valid protocols. An FRX4000 port can be configured as any WAN protocol loaded
in the device. An FRX6000 or FRM port can be configured as any WAN protocol con-
figured on this port's RLP. (Protocol configuration is described in Chapter 4.)
Table 8-2 SNA Port PU Parameters
Valid Values
up to 10 characters
0–15 characters
0–15 characters
25–4105
Y/N
(sec)
15–255
0–255
Active, Inactive
0–255
1
Y/N
Two-way Alternate,
Two-way Simultaneous
0–fc
0–ffffffffffff
0–fff
0–fffff
0–250
100–5000
1–50
1–127
1–127
0–255
0–9
4
0–16
is configured in Port Configuration for
0
to ensure that the remote link station will receive the
T1
T1 expires.
Default Value
none
none
none
265
N
60
(indefinite)
0
Active
0
N
Two-way Alternate
2
(hex) 04
000000000000
000
00000
10
4
100
30
1
1
8
0
0
Y .
or
Priority Bandwidth Allo-
8-5