Configuring Default Node-Wide Bridging Parameters
Configuring Bridging
If one or more Bridge ports (interfaces) will be established in the local node, certain
parameters must be configured to define bridge operation. Press
LAN Default Parameters Menu (or
prompted, enter:
– if also configuring LLC2 or Bridging in the node, enter a value
Virtual LAN ID
of
(hex). Otherwise, press
0–fff
LAN IDs can also be configured in LLC2 Interface/Bridge Port
records (later in this chapter). Each LAN ID must be unique
within the network on which this node will operate.
Any remaining requested information, referring to Table 13-1 (on page 13-4).
Con figu re Bridge/LLC 2 N ode Defaults
A V irtual LA N ID
B Bridge Enab led
C Bridge Hello Time
D Bridge Max A ge
E Bridge Forw ard D elay
F
Bridge Aging Timer (s econd s)
G Bridge Priority
H Max S ize Bridge Forw ard in g Tab le
I
I P Bridging Enab led
J
I PX Brid gin g En abled
K S RB I D
L D efau lt Ethern et Frame Typ e
Option::
Figure 13-1 Bridge Node Defaults Configuration Screen
from the Main Menu). When
[A], [A], [E], [B]
(accepting the default of
[Enter]
Node N ame=nod e_xyz
000
N
2
20
15
300
0
65535
N
N
0
Type II
[A],[A],[E],[B]
from Main Menu
at the Configure
[B]
).
000
13-3