Table of Contents
Advertisement
clear lacp singleportlag
Defaults
None.
Mode
Switch command, read‐write.
Usage
When single port LAGs are enabled, Link Aggregration Groups can be formed when only one
port is receiving protocol transmissions from a partner. When this setting is disabled, two or more
ports are required to form a LAG.
This setting has no effect on existing LAGs created with multiple member ports. It also does not
prevent previously formed LAGs from coming up after they have gone down, as long as any
previous LAG member ports comes up connected to the same switch as before the LAG went
down.
Example
This example enables the formation of single port LAGs:
B3(su)->set lacp singleportlag enable
clear lacp singleportlag
Use this command to reset the single port LAG function back to the default state of disabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the single port LAG function back to disabled:
B3(su)->clear lacp singleportlag
show port lacp
Use this command to display link aggregation information for one or more underlying physical
ports.
Syntax
show port lacp port port-string {[status {detail | summary}] | [counters]}
5-42 Port Configuration
Advertisement
Table of Contents
