Table of Contents
Advertisement
show tftp settings
Use this command to display TFTP settings used by the switch during data transfers using TFTP.
Syntax
show tftp settings
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
The TFTP timeout value can be set with the set tftp timeout command. The TFTP retry value can
be set with the set tftp retry command.
Example
This example shows the output of this command.
B3(ro)->show tftp settings
TFTP packet timeout (seconds): 2
TFTP max retry: 5
set tftp timeout
Use this command to configure how long TFTP will wait for a reply of either an acknowledgement
packet or a data packet during a data transfer.
Syntax
set tftp timeout seconds
Parameters
seconds
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets the timeout period to 4 seconds.
B3(rw)->set tftp timeout 4
Specifies the number of seconds to wait for a reply. The valid range is
from 1 to 30 seconds. Default value is 2 seconds.
show tftp settings
SecureStack B3 Configuration Guide 3-47
Advertisement
Table of Contents
