Table of Contents
Advertisement
Command Reference
E4981A SCPI Commands
The transfer format of data read out with this command conforms to the setup
made with the
If the comparator function is disabled (OFF has been specified with the
:CALCulate1:COMParator[:STATe]
{numeric1}, {numeric2}, and {numeric3}, are read out.
{numeric 1}, {numeric 2}, {numeric 3}, and {numeric 4} are as follows:
Query response
{numeric 1},{numeric 2},{numeric 3},{numeric 4}<newline><^END>
Related commands
:READ?
*TRG
:FORMat[:DATA]
:CALCulate1:COMParator[:STATe]
Equivalent key
No equivalent key is available on the front panel.
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
:FORMat[:DATA]
{numeric 1}: Measurement status (one of the integers between 0 and 3
listed below)
0: No error
1: Detection of overload (OVLD)
2: Detection of Low C or No Contact (See
:FORMat:STATus:EXTension
{numeric 2}: Measured value of the primary parameter
{numeric 3}: Measured value of the secondary parameter
{numeric 4}: Comparator sorting result (an integer between 0 and 11
listed below)
0: Sorted into OUT_OF_BINS.
1: Sorted into BIN1.
2: Sorted into BIN2.
3: Sorted into BIN3.
4: Sorted into BIN4.
5: Sorted into BIN5.
6: Sorted into BIN6.
7: Sorted into BIN7.
8: Sorted into BIN8.
9: Sorted into BIN9.
10: Sorted into AUX_BIN.
11: OVLD (Overload) or NC (No contact) [sorting not possible]
on page 230
on page 163
on page 225
command. (Query only)
command), only three data items,
on page
224)
on page 187
221
Advertisement
Table of Contents
