Data:points[:Data] - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:DATA:POINts[:DATA]

Syntax :DATA:POINts[:DATA] {BUF1|BUF2|BUF3},<numeric>
:DATA:POINts[:DATA]? {BUF1|BUF2|BUF3}
Description Specifies the size of data buffer 1, data buffer 2, or data buffer 3 in number of
measurements. Executing this command returns the pointer to the specified
data buffer (the location to feed measurement data) back to the start.
Parameters
BUF1
BUF2
BUF3
Description
Range
Initial value
Resolution
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
Query response {numeric}<newline><^END>
Related commands
:DATA:FEED:BUF1
:DATA:FEED:CONTrol[:STATe]
Equivalent key No equivalent key is available on the front panel.
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Description
Specifies data buffer 1 as the buffer to which the <numeric> setup
is applied or reads out the setup of data buffer 1.
Specifies data buffer 2 as the buffer to which the <numeric> setup
is applied or reads out the setup of data buffer 2.
Specifies data buffer 3 as the buffer to which the <numeric> setup
is applied or reads out the setup of data buffer 3.
<numeric>
Number of measurements for the data buffer specified with
{BUF1|BUF2|BUF3}
Data buffer 1: 1 to 200
buffer 2: 1 to 200
3: 1 to 1000
Data buffer 1: 200
buffer 2: 200
3: 1000
1
on page 195
on page 200
Data
Data buffer
Data
Data buffer
205