Trigger[:Seq1]:Delay - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TRIGger[:SEQ1]:DELay

Syntax :TRIGger[:SEQ1]:DELay <numeric>[mS|S]
:TRIGger[:SEQ1]:DELay?
Description Specifies the waiting time between when a trigger is inputted and when the
measurement signal is outputted (source delay time). The source delay time is
valid only when the synchronous source function is enabled (SYNC, with the
:SOURce:VOLTage:MODE
Parameters
Description
Range
Initial value
Unit
Resolution
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
A fraction below the resolution is rounded off. MAX or MIN can be used to
specify the parameters.
{numeric}<newline><^END>
Query response
Equivalent key [Meas Setup] - SRC DLY
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 269).
<numeric>
Source delay time
0 to 1
0
s (second)
100u
303