Table of Contents
Advertisement
Setting Up Measurement Conditions and Display
Setting Up Display
Setting Up Display
Turning ON/OFF display
To turn ON/OFF display of the measurement parameter obtained, the
measurement signal level monitored, the handler output (comparator sorting
result), the multi-correction settings, and the correction data, use the following
command.
•
Setting up measurement result display
You can set up the following items related to the measurement result display.
•
The following table shows the commands used to set up the above items.
Setup item
Fixed point
display
Selecting items displayed in instrument setup display area
To select a display page for the part that displays the instrument setup at the
right of the display (instrument setup display area), use the following
command.
•
Displaying measurement result as deviation from reference value (deviation
measurement mode)
You can use the deviation measurement mode to display a relative
measurement result as deviation from the reference value instead of displaying
its absolute value. To turn ON/OFF the deviation measurement mode, use the
following commands.
•
•
44
:DISPlay[:WINDow][:STATe]
Fixed point display
• ON/OFF
• Value of highest digit
ON/OFF
Value of highest digit
on page 213
:DISPlay:PAGE
:CALCulate1:MATH:STATe
:CALCulate2:MATH:STATe
on page 215
Command
:DISPlay[:WINDow]:TEXT1[:DATA]:
FMSD[:STATe]
:DISPlay[:WINDow]:TEXT1[:DATA]:
FMSD:DATA
on page 190
on page 193
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 217
on page 216
Advertisement
Table of Contents
