Table of Contents
Advertisement
Starting (Triggering) Measurement and Waiting for Completion of Measurement
Starting (Triggering) Measurement
Figure 5-2
Transition flow from waiting for trigger state to measurement state
e4981ape0051
Measurement state (sequence operation state)
Measurement is performed in the measurement state. After transiting from
"Waiting for trigger state (trigger event detect state)"
state, then wait for trigger delay and source delay
finished, the state transitions to a different state depending on the setup of the
continuous activation of the trigger system (set with :INITiate:CONTinuous
on page
When the continuous activation is OFF:
When the continuous activation is ON:
Starting (triggering) measurement
Follow the procedure below to perform successive measurements
automatically (initial setup).
Step 1.
Set the trigger mode to the internal trigger with the
:TRIGger[:SEQ1]:SOURce
Step 2.
If the trigger system has not started up (in the idle state), use the
:INITiate:CONTinuous
activation of the trigger system.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
W aiting for T rig g er S tate
:TRIG
executed
Trigger
D etec ted
Trigger
Trigger S ource S et
(S e t w ith :TRIG:SOUR)
In te rn a l
E x te rn a l
227) as shown below.
Transition to the idle state (c in
Transition to the waiting for trigger state (d in
command on page
command on page 227
B u s
M a n u a l
.
When the measurement is
Figure
305.
to turn ON the continuous
To M easurem ent S tate
to the measurement
5-1)
Figure
5-1)
59
Advertisement
Table of Contents
