Test:handler:status:rdytrig - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:HANDler:STATus:RDYTrig

Syntax :TEST:HANDler:STATus:RDYTrig {ON|OFF|1|0}
Description This command sets the Handler Ready for Trigger signal for test purpose and
can be used to check/troubleshoot the Test pin signal of Handler interface. (No
Query)
When
can be controlled/read by: TEST:HAND:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
Parameters
ON
OFF
Related commands
:TEST:HANDler:STATus:ALARm
:TEST:HANDler:STATus:INDex
:TEST:HANDler:STATus:NC
:TEST:HANDler:STATus:OVLD
Equivalent key No equivalent key is available on the front panel.
sequence
296
:TEST:HANDler:MODE
:TEST:HANDler:MODE
Description
Sets Handler Ready for Trigger signal status to ON.
Sets Handler Ready for Trigger signal status to OFF.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
is set to ON, the interface pin signal value
should set to OFF so that handler interface
on page 291
on page 293
on page 294
on page 295