Sre; Stb - Keysight E4981A Programming Manual

Command Reference
IEEE Common Commands

*SRE

Syntax *SRE <numeric>
*SRE?
Description Sets the value of the Service Request Enable Register.
Parameters
Description
Range
Initial value
Resolution
If the specified parameter is out of the allowable setup range, "Out of range"
error is generated. Note that bit 6 cannot be set to 1.
Query response {numeric}<newline><^END>
Related commands
*ESE
:STATus:OPERation:ENABle
Equivalent key No equivalent key is available on the front panel.
sequence

*STB?

Syntax *STB?
Description Reads out the value of the Status Byte Register. (Query only)
Query response {numeric}<newline><^END>
Equivalent key No equivalent key is available on the front panel.
sequence
162
<numeric>
Setup value of the register
0 to 255
0
1
on page 157
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 270