Data:reference1:Fill; Data:reference2:Data - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:DATA:REFerence1:FILL

Syntax :DATA:REFerence1:FILL
Description Execute a single measurement and set the measured value into the primary
and secondary reference values for deviation. This command is same as
:DATA:REFerence2:FILL
Related commands
:DATA:REFerence2:FILL
Equivalent key [Meas Setup] - REF A - MEASURE
sequence

:DATA:REFerence2:DATA

Syntax :DATA:REFerence2:DATA <numeric>
:DATA:REFerence2:DATA?
Description Sets or reads out the reference value for the secondary parameter used in the
deviation measurement mode.
The functionality of this command is same as
REF2.
Parameters
Range
Initial value
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
Query response {numeric}<newline><^END>
Related commands
:DATA:REFerence1:DATA
Equivalent key [Meas Setup] - REF A or B
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 208. (No Query)
on page 208
<numeric>
-99.9999G to 99.9999G
0
on page 206
with value of
:DATA[:DATA]
207