Table of Contents
Advertisement
Then
Then
Use the ▲|▼ arrows to select ON.
Use
Limit Options
How to set Limit Options
Press
Then Options.
Then choose from the following:
How to Save and Recall Limits
In addition to saving and recalling limits with an *.sta file, limit lines can also be
saved and then recalled independent of the current mode or measurement. Use this
feature to recall and apply existing limit lines to measurements with different settings
or even a different frequency range.
Limit line files can be loaded into the FieldFox Data Link Software. Learn how in the
help file that is included in the Data Link software.
How to Save and Recall Limits
Press Save/Recall then
Then press Limit .
Then choose from the following:
Data Analysis Features
Edit
Limits.
Trace. A limit line table appears.
Build From
to shift the limit line UP or DOWN. Learn how below.
Offset
if the limit table is visible.
Exit
Beep
o
Audible beep sounds when a sweep passes.
o
On Pass
Audible beep sounds when a sweep fails.
o
On Fail
No audible beep sounds.
o
Off
Shows
Warning On Off
o
Data points that fail are highlighted.
Limit Type
o
Shifts the limit line up or down. Enter an offset value using the rotary
Offset
o
knob, the ▲|▼ arrows, or by entering a value with the number keys.
Enter a positive offset to shift the limit line UP, usually used with UPPER
o
limits.
Enter a negative offset to shift the limit line DOWN, usually used with LOWER
o
limits.
Shifts the limit line up or down like an offset, but only virtually. The limit
Margin
o
line does NOT appear to move. Enter a Margin value using the rotary knob, the
▲|▼ arrows, or by entering a value with the number keys.
Enter a positive margin to virtually shift the limit line UP.
o
Enter a negative margin to virtually shift the limit line DOWN.
o
USB flash drive) to be used for the Save or Recall. Learn more on page 126.
Pass
or
Fail
indication on the display with each sweep.
to set the Device (Internal, SD card, or
Select Device
121
Advertisement
Chapters
Table of Contents
