Table of Contents
Advertisement
Command Reference
E4981A SCPI Commands
When specifying BUF3 as parameter (Comparator: ON)
{numeric 1},{numeric 2},{numeric 3},{numeric 4},...,{numeric (N×4)}<newline><^END>
The N sets of measurement data (a data set consists of the measurement
status, measured value, and comparator sorting result) fed into the data buffer
are read out in the order of measurement.
Where N is the number of measurement points specified with the
:DATA:POINts:BUF3
Related commands
:DATA:FEED:BUF1
:DATA:FEED:CONTrol[:STATe]
:DATA:POINts:BUF1
:DATA:POINts:BUF2
:DATA:POINts:BUF3
:CALCulate3:MATH:STATe
:CALCulate4:MATH:STATe
:FETCh?
:FORMat[:DATA]
Equivalent key
No equivalent key is available on the front panel.
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
command and n is an integer between 1 and N:
The measurement status in the n-th measurement (an integer
{numeric (n–1)×3+1}
between 0 and 2).
The measured value of the primary parameter in the n-th
{numeric (n–1)×3+2}
measurement. If overload is detected, 9.9E37 is outputted.
The measured value of the secondary parameter in the n-th
{numeric (n–1)×3+3}
measurement. If overload is detected, 9.9E37 is outputted.
The comparator sorting result in the n-th measurement (an
{numeric (n–1)×3+4}
integer between 0 and 11). The output (output value is 11) is
produced even if the comparator is off.
on page 195
on page 202
on page 203
on page 204
on page 220
on page 225
on page 200
on page 194
on page 194
211
Advertisement
Table of Contents
