Calibration:cable:correction:state - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:CALibration:CABLe:CORRection:STATe?

Syntax :CALibration:CABLe:CORRection:STATe? <numeric>
Description Gets cable correction ON/OFF. (Query Only)
Parameters
Description
Range
The value of this command is not changed with
and is only changed with Factory Default reset (available only through
Front Panel).
{1|0}<newline><^END>
Query Response
Related commands
:CALibration:CABLe:CORRection:CLEar
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:LOAD
page 166
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:OPEN
page 167
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:REFerence
page 168
:CALibration:CABLe:CORRection:SAVE
Equivalent key No equivalent key is available on the front panel.
sequence
170
<numeric>
Cable Length (in meters)
1or 2
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
and
*RST :SYSTem:PRESet
on page 165
on page 169
on
on
on