Data:points:buf3 - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:DATA:POINts:BUF3

Syntax :DATA:POINts:BUF3 <numeric>
:DATA:POINts:BUF3?
Description Specifies the size of data buffer 3 in number of measurements. Executing this
command returns the pointer to the specified data buffer (the location to feed
measurement data) back to the start.
The functionality of this command is same as
value of BUF3.
Parameters
Description
Range
Initial value
Resolution
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response {numeric}<newline><^END>
Related commands
:DATA:FEED:CONTrol:BUF3[:STATe]
:DATA:FEED:CONTrol[:STATe]
Equivalent key No equivalent key is available on the front panel.
sequence
204
<numeric>
Number of measurements for the data buffer specified with BUF3
1 to 1000
1000
1
on page 199
on page 200
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
:DATA:POINts[:DATA]
with