Command Reference
E4981A SCPI Commands
:TEST:HANDler:BIN
Syntax
:TEST:HANDler:BIN <numeric>
Description
This command sets the Handler Bin No for test purpose and can be used to
check/troubleshoot the Test pin signal of Handler interface. (No query)
When
can be controlled/read by: TEST:HAND:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
Parameters
Numeric Value
0
1-9
10
11
Related Commands
:TEST:HANDler:COMP
:TEST:HANDler:KEYLock?
:TEST:HANDler:MODE
Equivalent key
No equivalent key is available on the front panel.
sequence
288
:TEST:HANDler:MODE
:TEST:HANDler:MODE
Description
Out of Bins
BIN 1 to 9
AUX BIN
All Off
on page 289
on page 289
on page 290
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
is set to ON, the interface pin signal value
should set to OFF so that handler interface