Table of Contents
Advertisement
Preparation for Accurate Measurement (Executing Correction)
Using the Multi-correction Function
Using the Multi-correction Function
Turning ON/OFF the multi-correction function
To turn ON/OFF the multi-correction function, use the following command.
•
Selecting a channel
To select a channel for the multi correction function, use the following
command.
•
Measuring correction data
Selecting the definition method of the LOAD correction standard
To select whether to define the LOAD correction standard value (LOAD
correction reference value) for each channel individually or for all channels
commonly, use the following command.
•
Measuring correction data
The method to measure the OPEN/SHORT/LOAD correction data for
multi-correction is the same as that for basic correction data except that you
need to select the proper channel before measurement. For more details, refer
to
Reading/writing correction data
The method used to read/write the OPEN/SHORT/LOAD correction data for
multi-correction is the same as that for basic correction data except that you
need to select the proper channel before measurement. For more details, refer
to
on page
Sample program
See
54
[:SENSe]:CORRection:MULTiple[:STATe]
[:SENSe]:CORRection:MULTiple:CHANnel
[:SENSe]:CORRection:MULTiple:CKIT:STAN3[:STATe]
"Measuring correction data" on page
"Reading/writing correction data (saving/recalling correction conditions)"
51.
Example 9-4
to view an example of multi-correction.
50.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 245
on page 243
on page 244
Advertisement
Table of Contents
