Table of Contents
Advertisement
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Programming Manual
10 Command Reference
This chapter provides the SCPI command reference for the Keysight E4981A.
Each command is fully described and ordered alphabetically based on its
abbreviated name format. Use the index to look up a SCPI command by its full
syntax. To find a command according to its function, refer to the
Command Table" on page
Notational Conventions in this Command Reference
This section describes the rules to read the description of the commands in this
chapter.
Description
A part with the heading "Description" describes how to use the command or
the operation when executed.
Syntax
A part with the heading "Syntax" describes the syntax to send a command from
the external controller to the E4981A. A syntax con...sists of a command part
and a parameter part. A space is used to separate the command part and the
parameter part.
If there are several parameters, a comma is used instead as the separator
between adjacent parameters. Three periods (...) between commas indicate
that parameters in that part are omitted. For example, <numeric 1>,...,
<numeric 4> indicates that four parameters,<numeric 1>, <numeric 2>,
<numeric 3>, and <numeric 4>, are required.
String-type parameters, <string>, <string 1>, and so on, must be enclosed in
double quotation marks ("). Furthermore, <block> indicates block-format data.
You can omit the lowercase letters in syntax. For example,
":CALibration:CABLe[:LENGth] " can be shortened to "CAL:CABL."
307.
"SCPI
Advertisement
Table of Contents
