Calculate1:Comparator:primary:bin{1-9}[:Limit] - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:CALCulate1:COMParator:PRIMary:BIN{1-9}[:LIMIT]

Syntax :CALCulate1:COMParator:PRIMary:BIN{1|2|3|4|5|6|7|8|9}[:LIMIT] <numeric
1>,<numeric 2>
:CALCulate1:COMParator:PRIMary:BIN{1|2|3|4|5|6|7|8|9}[:LIMIT]?
Description Sets the low and high limit ranges of BIN1 to BIN9 as the primary parameter
used in the comparator function, depending on the designation method set
using the
This command only sets the limit range. To activate it, use the
:CALCulate1:COMParator:PRIMary:BIN{1-9}:STATe
the BIN for which the limit range has been set.
Parameters
Description
Range
Initial value
Unit
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
The unit of the parameter may change depending on the limit range
designation method.
{numeric 1},{numeric 2}<newline><^END>
Query response
Related commands
:CALCulate1:COMParator:MODE
:CALCulate1:COMParator:PRIMary:BIN{1-9}:STATe
:CALCulate1:COMParator:SECondary:LIMit
:CALCulate1:COMParator[:STATe]
Equivalent key [Meas Setup] - LIMIT TABLE - BIN{1|2|3|4|5|6|7|8|9}- LOW, HIGH
sequence
182
:CALCulate1:COMParator:MODE
<numeric 1>
The lower limit value of the limit
range.
-999.999 to 999.999
0
F (farad) or % (percent)
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
command.
<numeric 2>
The upper limit value of the
limit range.
-999.999 to 999.999
0
F (farad) or % (percent)
on page 181
on page 185
on page 187
command to turn on
on page 183