Trg; Tst; Wai - Keysight E4981A Programming Manual

Command Reference
IEEE Common Commands

*TRG

Syntax *TRG
Description If the trigger source is set to BUS (set with the
command), triggers the E4981A as it waits for a trigger and reads out the
measured data after the measurement is completed.
The transfer format of data read out with this command conforms to the setup
of the
Although this command does not have "?", a query response is given.
It is the same as that of the
Query response
description of :FETCh?.
Related commands
:FETCh?
:TRIGger[:SEQ1]:SOURce
:FORMat[:DATA]
:READ?
:FORMat:STATus:EXTension
Equivalent key [Trigger]
sequence

*TST?

Syntax *TST?
Description Does nothing. The self-test is not executed by this command in the case of the
E4981A. Always returns 0. (Query Only)
Equivalent key No equivalent key is available on the front panel.
sequence

*WAI

Syntax *WAI
Description Waits until all commands sent before this command are executed. (No query)
Equivalent key No equivalent key is available on the front panel.
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
command.
:FORMat[:DATA]
:FETCh?
on page 220
on page 225
on page 230
:TRIGger[:SEQ1]:SOURce
command. For details, refer to the
on page 305
on page 224
163