Test:handler:status:nc - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:HANDler:STATus:NC

Syntax :TEST:HANDler:STATus:NC {ON|OFF|1|0}
Description This command sets the Handler No Contact/Low C Reject signal for test
purpose and can be used to check/troubleshoot the Test pin signal of Handler
interface. (No Query)
When
can be controlled/read by: TEST:HAND:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
Parameters
ON
OFF
Related commands
:TEST:HANDler:STATus:ALARm
:TEST:HANDler:STATus:INDex
:TEST:HANDler:STATus:OVLD
:TEST:HANDler:STATus:RDYTrig
Equivalent key No equivalent key is available on the front panel.
sequence
294
:TEST:HANDler:MODE
:TEST:HANDler:MODE
Description
Sets No Contact/Low C Reject status to ON.
Sets No Contact/Low C Reject status to OFF.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
is set to ON, the interface pin signal value
should set to OFF so that handler interface
on page 291
on page 293
on page 295
on page 296