Preparation for Accurate Measurement (Executing Correction)
Using the Cable Correction Function
Using the Cable Correction Function
Turning ON/OFF the cable correction function
To turn ON/OFF the cable correction function, use the following command:
•
Executing LOAD measurement in cable correction
To execute LOAD measurement in cable correction, use the following
command:
•
Executing OPEN measurement in cable correction
To execute OPEN measurement in cable correction, use the following
command:
•
Executing REFerence measurement in cable correction
To execute REFerence measurement in cable correction, use the following
command:
•
Saving cable correction data
To save the cable correction data, use the following command:
•
Clearing cable correction data
To clear the cable correction data, use the following command:
•
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
:CALibration:CABLe:CORRection:STATe?
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:LOAD
page 166
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:OPEN
page 167
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:REFerence
on page 168
:CALibration:CABLe:CORRection:SAVE
:CALibration:CABLe:CORRection:CLEar
on page 170
on page 169
on page 165
on
on
55