Calculate1:Comparator:primary:nominal - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:CALCulate1:COMParator:PRIMary:NOMinal

Syntax :CALCulate1:COMParator:PRIMary:NOMinal <numeric>
:CALCulate1:COMParator:PRIMary:NOMinal?
Description Specifies the reference value used when specifying the primary parameter limit
range for the comparator function. This value can be used when the limit range
designation method is set to either absolute tolerance mode or percent
tolerance mode.
Parameters
Description
Range
Initial value
Unit
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response {numeric}<newline><^END>
Related commands
:CALCulate1:COMParator:MODE
:CALCulate1:COMParator:PRIMary:BIN{1-9}[:LIMIT]
Equivalent key [Meas Setup] - LIMIT TABLE - NOM
sequence
184
<numeric>
The reference value used when specifying the primary parameter
limit range.
-999.999 to 999.999
0
F (farad)
on page 181
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 182