Source:voltage:mode; Status:operation:condition - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:SOURce:VOLTage:MODE

Syntax :SOURce:VOLTage:MODE {CONTinuous|SYNChronous}
:SOURce:VOLTage:MODE?
Description Determines whether to use the synchronous source function (to output the
measurement signal only during measurement) or not (to always output the
measurement signal). The synchronous source function lets you set the source
delay time with the
output during the waiting time after a trigger is generated.
Parameters
CONTinuous
SYNChronous
Query Response {CONT|SYNC}<newline><^END>
Equivalent key [Meas Setup] - SYNC SRC- ON|OFF
sequence

:STATus:OPERation:CONDition?

Syntax :STATus:OPERation:CONDition?
Description Reads out the value of the Operation Status Condition register. (Query only)
Query response {numeric}<newline><^END>
Equivalent key No equivalent key is available on the front panel.
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
":TRIGger[:SEQ1]:DELay" on page
Description
Always outputs the measurement signal.
Outputs the measurement signal only during measurement.
303, to suspend the signal
269