Test:scanner:ch - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:SCANner:CH?

Syntax :TEST:SCANner:CH?
Description This command gets the Scanner channel number for test purpose and can be
used to check/troubleshoot the Test pin signal of Scanner interface. (Query
Only)
When
can be controlled/read by: TEST:SCAN:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
<numeric><newline><^END>
Query response
Related commands
:TEST:SCANner:EOM
:TEST:SCANner:INDex
:TEST:SCANner:MODE
:TEST:SCANner:TRIGger?
:TEST:SCANner:VALid?
Equivalent key No equivalent key is available on the front panel.
sequence
298
:TEST:SCANner:MODE
:TEST:SCANner:MODE
on page 299
on page 300
on page 301
on page 302
on page 302
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
is set to ON, the interface pin signal value
should set to OFF so that scanner interface