Test:handler:trigger; Test:rear:trigger - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:HANDler:TRIGger?

Syntax :TEST:HANDler:TRIGger?
Description This command gets the Handler Trigger signal for test purpose and can be
used to check/troubleshoot the Test pin signal of Handler interface. (Query
Only)
When
can be controlled/read by: TEST:HAND:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
{1|0}<newline><^END>
Query response
Related commands

:TEST:REAR:TRIGger?

Equivalent key No equivalent key is available on the front panel.
sequence
:TEST:REAR:TRIGger?
Syntax :TEST:REAR:TRIGger?
Description This command gets the BNC Trigger signal for test purpose and can be used to
check/troubleshoot the Test pin signal of Handler interface. (Query Only)
When
can be controlled/read by: TEST:HAND:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
{1|0}<newline><^END>
Query response
Related commands
:TEST:HANDler:TRIGger?
Equivalent key No equivalent key is available on the front panel.
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
:TEST:HANDler:MODE
:TEST:HANDler:MODE
on page 297
:TEST:HANDler:MODE
:TEST:HANDler:MODE
on page 297
is set to ON, the interface pin signal value
should set to OFF so that handler interface
is set to ON, the interface pin signal value
should set to OFF so that handler interface
297