Table of Contents
Advertisement
Reading Out Measured Result
Reading Out Measured Result
Figure 6-9
Structure of data buffer
Procedure for use
Step 1.
Use the :DATA:POINts:BUF1
measurements you want to feed into the data buffer.
Step 2.
When you use buffer 1 or buffer 2, use the :DATA:FEED:BUF1
page 195
secondary parameter.
Step 3.
Use the :DATA:FEED:CONTrol[:STATe]
setup feed the measured result into the data buffer.
Step 4.
Execute the measurement for the number of times specified in Step 1.
Step 5.
Use the :DATA[:DATA]
temporarily stored in the data buffer.
Step 6.
Repeat Steps 4 to 5.
Sample program
See
data buffer.
70
to select whether the parameter is fed from the primary or
command on page 208
Example 9-12
to view an example of reading out measured result using
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
command on page 202
command on page 200
to read out the data
to set up the number of
command on
to make the
Advertisement
Table of Contents
